Asko T794C Operating Instructions - Page 18

Troubleshooting The machine will not start Check • that the door is properly closed. • that the main power switch is on. • that the Delayed Start option has not been selected. To cancel Delayed Start, press the Stop button for three seconds. • that any plug is connected. • that the house fuses or circuit breaker have not been tripped. • that the overheating cut-out has not been triggered. The machine loses all power during a program The overheating cut-off shuts off the tumble dryer if the temperature is too high, caused by lint clogging the lint filter, for instance. • Clean the lint filter. • Check that the condenser is clean. Clean it if necessary. See the Care and maintenance instructions chapter. • Wait until the machine has cooled, then try starting it. If it still does not start: Call the Customer Care Center. Drying takes too long • Check that the lint filter is not blocked. See the Care and maintenance instructions chapter. • Check that the condenser is not blocked. See the Care and maintenance instructions chapter. • Prolonged drying times may also be due to the tumble dryer being located in a confined area or in a room that is too small, causing the air to become too hot. • Make sure that the tumble dryer has access to more cold air, open doors and/or windows, for example. Error messages • If Overflow is shown in the display, the condenser drain hose could be blocked. Remove the hose from the drain and check for obstructions. The hose should be inserted no more than 5 or 6 inches into the wall drain. • Read Drying takes too long in this chapter if Max Program Time appears on the display. • If Clean Lint Filter appears on the display, clean the lint filter. • If Clean condenser appears on the display, clean the condenser. See the Care and maintenance instructions chapter. • Call the Customer Care Center if Thermistor Fault appears on the display. • Press the Stop button to close any error messages. 18 Customer Care Center 1-800-898-1879 www.askousa.com