Asko W660 User manual Use & Care Guide EN ES FR - Page 16
Electrical Connections, Drain Outlet Connection, Freestanding Installation, Built-in Installation,
View all Asko W660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
DRAIN OUTLET CONNECTION The machine is supplied with the outlet hose already attached. The hose should be extended over a suitable sink edge or drain pipe at a height of 24 to 36 (600 mm to 900 mm) above the floor. (The lower height is preferable.) Make sure that the hose is not kinked. NOTE: If the hose is extended, the internal diameter of the coupling must not be less than 1/2. FREESTANDING INSTALLATION The washer can be placed next to the dryer. It is essential that the machine is leveled and the locknuts are tight to prevent excessive vibration during the spin cycles. Also be sure to leave a minimum of 1/2 inch (12.5 mm) of space between the washer and the dryer. WARNING! Do not extend the drain hose higher than 36 (900 mm). ELECTRICAL CONNECTIONS The machine is delivered ready-fitted with a plug and is intended for connection to an ASKO Dryer, which is equipped with a matching receptacle. The plug supplied with the washer can only be used with an ASKO Dryer. If the washer is used separately or with another dryer, it must be on a separate 220 V single-phase circuit. If the machine is to be used in a wet area, the supply must be protected by a residual current device. As supplied: 230 V, 60 Hz 2000 W heating element 15 A fuse required WARNING! Connection to a permanently wired supply point must be made only by a qualified electrician. GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING! Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded. Do not modify the plug provided with the appliance. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. BUILT-IN INSTALLATION ASKO washers can be installed beneath a cabinet or worktop with a height of 34. There must be a gap of about 1/4 (.64 mm) all around the machine, including between the rear edge of the machine top panel and the back wall. The opening width must be at least 24 (600 mm). Space must also be available for the inlet and drain hoses. See the diagram below for measurements and positions. If the drain outlet is higher than 24, you will need to recess the connections. NOTE: The height adjustment for the washer is 33-1/2 to 34-1/2 (850 mm to 876 mm). Do not raise it higher than 34-1/2. STACKED INSTALLATION ASKO washers should never be stacked on a counter or a dryer. You can, however, stack an ASKO dryer on an ASKO washer. Refer to your Dryer Use and Care Guide for instructions on how to do this. Page 16