Asus B150M-A User Guide - Page 22

Connectors, Rear panel connectors

Get Asus B150M-A PDF manuals and user guides View all Asus B150M-A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

2. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. +5VSB_MB Chassis Signal GND CHASSIS B150M-A B150M-A Chassis intrusion connector 1.7 1.7.1 1 Connectors Rear panel connectors 2 3 45 12 11 10 9 8 7 6 1. PS/2 mouse port (green). This port is for a PS/2 mouse. 2. Video Graphics Adapter (VGA) port. This 15-pin port is for a VGA monitor or other VGA-compatible devices. 3. LAN (RJ-45) port. These ports allow Gigabit connection to a Local Area Network (LAN) through a network hub. 1-12 Chapter 1: Product introduction

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
1-12
Chapter 1: Product introduction
1.7
Connectors
1.7.1
Rear panel connectors
2
45
3
6
8
7
1
11
9
10
12
1.
PS/2 mouse port (green).
This port is for a PS/2 mouse.
2.
Video Graphics Adapter (VGA) port.
This 15-pin port is for a VGA monitor or other
VGA-compatible devices.
3.
LAN (RJ-45) port.
These ports allow Gigabit connection to a Local Area Network
(LAN) through a network hub.
2.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
B150M-A
B150M-A Chassis intrusion connector
+5VSB_MB
Chassis Signal
GND
CHASSIS