Asus B75M-A B75M-A User's Manual - Page 42
Intel, B75 Serial ATA 6.0Gb/s connector 7-pin SATA6G_1 [gray], USB 3.0 connector 20-1 pin USB3_34
View all Asus B75M-A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
7. Intel® B75 Serial ATA 6.0Gb/s connector (7-pin SATA6G_1 [gray]) This connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s signal cables. B75M-A SATA6G_1 GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXN1 RSATA_RXP1 GND B75M-A SATA 6.0Gb/s connector • You must install Windows. XP Service Pack 3 or later version before using Serial ATA hard disk drives. • When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to [AHCI]. See section 2.5.3 SATA Configuration for details. 8. USB 3.0 connector (20-1 pin USB3_34) This connector is for additional USB 3.0 ports. Connect the USB 3.0 bracket cable to this connector, then install the USB 3.0 bracket to the rear side of the chassis. If your chassis supports front panel ports, you can use the ASUS USB 3.0 header to install additional front panel USB 3.0 ports. USB3_34 IntA_P2_D+ IntA_P2_DGND IntA_P2_SSTX+ IntA_P2_SSTXGND IntA_P2_SSRX+ IntA_P2_SSRXVbus B75M-A PIN 1 ID IntA_P1_D+ IntA_P1_D- GND IntA_P1_SSTX+ GND IntA_P1_SSTXIntA_P1_SSRX+ IntA_P1_SSRX- Vbus B75M-A USB3.0 Front panel connector The USB 3.0 module is purchased separately. 1-30 Chapter 1: Product introduction