Asus DVD-E616P1 Install Manual - Page 12

Setting the Jumper Terminals Configure the jumpers to set the device to master or slave mode before physically installing it to your computer chassis. Use jumper blocks to short the pins to your desired setting. Make sure to correctly put the jumper blocks over the pins. Failure to do so may cause irreparable damage to the drive! JUMPER TERMINALS Master Mode RESERVED PIN 1 Cover the two pins labeled MA (see illustration) MA to set the DVD-ROM drive as a secondary master drive. This is possible only if your computer supports four IDE devices. The hard disk in the computer is set as Primary Master. Slave Mode Cover the two pins labeled SL (see illustration) to set the DVD-ROM drive as a slave device if your computer supports only two IDE devices. RESERVED If your computer supports four IDE devices, this setting sets your DVD-ROM drive either as a Primary Slave or a Secondary Slave. PIN 1 SL Cable Select Mode RESERVED PIN 1 Cover the two pins labeled CS (see illustration) if CS your computer supports a Cable Select (CSEL) signal. You need an exclusive interface cable for this setting. Refer to your computer manual for details. 12 ASUS DVD-E616P1 User Manual