Asus KGMH-D16 QDR User Guide - Page 41
LAN controller setting 3-pin LAN_SW1, LAN_SW2, Chassis intrusion connector 2 pin CHASSIS
View all Asus KGMH-D16 QDR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
4. LAN controller setting (3-pin LAN_SW1, LAN_SW2) These jumpers allow you to enable or disable the onboard Intel® Intel 82574LGigabit LAN controllers. Set to pins 1-2 to activate the Gigabit LAN feature. 5. Chassis intrusion connector (2 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. ASUS KGN(M)H-D16 2-23