Asus M4N68T-MV2 User Manual - Page 33
M4N68T-M Series IDE connector - motherboard
View all Asus M4N68T-MV2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
3. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for Ultra DMA 133/100 signal cable. There are three connectors on each Ultra DMA 133/100 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your devices: Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) - Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100 IDE devices. If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the same setting. PRI_IDE M4N68T-M V2 PIN1 NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. M4N68T-M Series IDE connector ASUS M4N68T-M Series 1-23