Asus P2L-B User Manual - Page 20

ASUS P2L-B User's Manual, The Motherboard As Shipped, Installing the Pentium II Processor, Mount

Get Asus P2L-B PDF manuals and user guides View all Asus P2L-B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

III. INSTALLATION The Motherboard As Shipped Four screws should be showing next to each corner of the SEC CPU Slot using two attach mount bridges from the underside of the motherboard. (1) SEC CPU slot NOTE: Encircled items are screws (2) from the mount bridges (1 & 2) Installing the Pentium II Processor: 1. Mount the Pentium II Retention Mechanism: The retention mechanism is designed to fit into the SEC slot only one way. TIP: Orient the mechanism's lock holes toward the motherboard's chipsets (see motherboard layout for the location of the Intel chipset). Be sure to align the notch in the mechanism with the small rib on one side of the slot and that the mechanism is properly seated on the board. Then, screw the captive nuts in place. WARNING! Do not overtighten the captive nuts. Doing so could damage your motherboard. Tighten captive nuts to no more than 6±1 inch/pound. III. INSTALLATION (CPU) (3) Captive nut Lock holes Captive nut 20 ASUS P2L-B User's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
20
ASUS P2L-B User’s Manual
III. INSTALLATION
(CPU)
III.
INSTALLATION
The Motherboard As Shipped
Four screws should be showing next to each corner of the SEC CPU Slot using two
attach mount bridges from the underside of the motherboard.
Installing the Pentium II Processor:
1.
Mount the Pentium II Retention Mechanism:
The retention mechanism is
designed to fit into the SEC slot only one way.
TIP:
Orient the mechanism’s lock holes toward the motherboard’s chipsets (see
motherboard layout for the location of the Intel chipset).
Be sure to align the notch in the mechanism with the small rib on one side of the
slot and that the mechanism is properly seated on the board. Then, screw the
captive nuts in place.
WARNING!
Do not overtighten the captive nuts. Doing so could damage your
motherboard. Tighten captive nuts to no more than 6±1 inch/pound.
NOTE:
Encircled items are screws
from the mount bridges
(1 & 2)
SEC CPU slot
(1)
(2)
Lock holes
Captive nut
Captive nut
(3)