Asus P2L-B User Manual - Page 32

III. INSTALLATION 18. ATX Power Supply Connector (ATXPWR, 20-pins) This connector connects to a ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT: Make sure that your ATX power supply can supply at least 10mAmp on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. For Wake on LAN support, your ATX power supply must supply at least 720mAmp. R +5.0 Volts +5.0 Volts -5.0 Volts Ground Ground Ground Power Supply On Ground -12.0Volts +3.3Volts +12.0Volts +5V Standby Power Good Ground +5.0 Volts Ground +5.0 Volts Ground +3.3 Volts +3.3 Volts III. INSTALLATION (Connectors) P2L-B ATX Power Connector 19. AT Power Supply Connector (POWER, 12-pins) This connector connects to a standard 5 Volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are together. RED RED RED WHT BLK BLK BLK BLK BLU YLW RED ORG +5V GND +12V PG R -5V -12V +5V Power Connector on Motherboard P8 P9 Power Plugs from Power Supply P2L-B AT Power Connector Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place. 32 ASUS P2L-B User's Manual