Asus P5BV Motherboard Installation Guide - Page 138
RAID Configuration
UPC - 610839159055
View all Asus P5BV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
5.4.2 JMicron® RAID Configuration The JMicron® Serial ATA controller allows you to configure RAID 0, RAID 1 and JBOD sets on the external Serial ATA hard disk drives. Before creating a RAID set Prepare the following items: 1. Two SATA HDDs, preferably with the same model and capacity. 2. A write-enabled floppy disk 3. Microsoft® Windows® OS installation disk (Windows 2000/XP) 4. Motherboard support CD with JMB363 driver Complete the following steps before you create a RAID set: 1. Install the external Serial ATA hard disk drives (HDDs) on your system. 2. Set the JMicron SATA Controller Mode item in the BIOS to [RAID]. See section "4.4.6 Onboard Devices Configuration" for details. HD Audio Controller [Enabled] Front Panel Support Type [AC97] Onboard PCIE GbE LAN [Enabled] LAN Option ROM [Disabled] JMicron SATA/PATA Controller [Enabled] JMicron SATA Controller Mode [RAID] Serial Port1 Address [3F8/IRQ4] Parallel Port Address [378] Parallel Port Mode [ECP] ECP Mode DMA Channel [DMA3] Parallel Port IRQ [IRQ7] 3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration. 4. Create a JMB363 RAID driver disk for Windows® OS installation. See section "5.5 Creating a RAID/SATA driver disk" for details. 5. Install the JMB363 driver after the Windows® OS had been installed. Always install the JMB363 driver before creating RAID sets. 5-32 Chapter 5: Software support