Asus P5P41T USB3 User Manual - Page 34

4. Serial ATA connectors (7-pin SATA1-6) These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the standard parallel ATA with 133 MB/s (Ultra DMA133). SATA1 SATA2 GND RSATA_TXN1 RSATA_TXP1 GND RSATA_RXN1 RSATA_RXP1 GND GND RSATA_TXN2 RSATA_TXP2 GND RSATA_RXN2 RSATA_RXP2 GND P5P41T/USB3 SATA3 SATA4 GND RSATA_TXN3 RSATA_TXP3 GND RSATA_RXN3 RSATA_RXP3 GND GND RSATA_TXN4 RSATA_TXP4 GND RSATA_RXN4 RSATA_RXP4 GND P5P41T/USB3 SATA connectors Install the Windows® XP Service Pack 2 or later version before using Serial ATA. 5. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. AAFP P5P41T/USB3 PIN 1 PORT1 L PORT1 R PORT2 R SENSE_SEND PORT2 L GND PRESENCE# SENSE1_RETUR SENSE2_RETUR HD-audio-compliant pin definition PIN 1 MIC2 MICPWR Line out_R NC Line out_L AGND NC NC NC Legacy AC'97 compliant definition P5P41T/USB3 Analog front panel connector • We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard's high-definition audio capability. • If you want to connect a high-definition front panel audio module to this connector, set the Front Panel Type item in the BIOS setup to [HD Audio]. If you want to connect an AC'97 front panel audio module to this connector, set the item to [AC97]. By default, this connector is set to [HD Audio]. See section 2.5.3 Onboard Devices Configuration for details. 1-24 Chapter 1: Product introduction