Asus P5QL-VM DO User Guide - Page 25
P5QL-VM DO Chassis intrusion connector
View all Asus P5QL-VM DO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
8. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports either High Definition Audio or AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. GND PRESENCE# SENSE1_RETUR SENSE2_RETUR AGND NC NC NC AAFP PIN 1 PIN 1 MIC2 MICPWR Line out_R NC Line out_L PORT1 L PORT1 R PORT2 R SENSE_SEND PORT2 L P5QL-VM DO HD-audio-compliant Legacy AC'97 pin definition compliant definition P5QL-VM DO Analog front panel connector If you want to connect a high-definition front panel audio module to this connector, ensure that the Front Panel Type item in the BIOS is set to [HD Audio]. If you want to connect an AC97 front panel audio module to this connector, set the item to [AC97]. See page 2-11 for details. 9. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and " Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS GND Chassis Signal P5QL-VM DO +5VSB_MB P5QL-VM DO Chassis intrusion connector 1-16 Chapter 1: Product introduction