Asus PCI-DA2000 User Manual - Page 37

Creating RAID

Get Asus PCI-DA2000 PDF manuals and user guides View all Asus PCI-DA2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

2. RAID Manager Creating New Drives 2. RAID Manager & Interface 8 Press [Esc] after selecting the drives and if a fault-tolerant RAID level (1,3 or 5) has been selected, the controller will start parity initialization. A progress indicator similar to the one shown below will be displayed. When initialization has finished, logical drive creation is complete. Creating RAID 87 % Complete 9 At this point, the logical drive has been partitioned into a single partition covering the entire drive capacity and is inaccessible to the host. 10 If different partitioning is desired, go to "Partition Logical Drive" (section 2.4.2.4.) menu to do the partitioning. 11 When the Logical Drive is properly partitioned, go to "View and Edit scsi id Map" (section 2.5.) menu to map the Logical Drive Partitions to LUNs. ASUS PCI-DA2000 Series RAID Controllers Driver Installation 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
31
2.
RAID Manager & Interface
2.
RAID Manager
Creating New Drives
8
Press
[Esc]
after selecting the drives and if a fault-tolerant RAID level (1,3 or 5)
has been selected, the controller will start parity initialization. A progress indi-
cator similar to the one shown below will be displayed. When initialization has
finished, logical drive creation is complete.
9
At this point, the logical drive has been partitioned into a single
partition covering the entire drive capacity and is inaccessible to the host.
10 If different partitioning is desired, go to “Partition Logical Drive”
(section 2.4.2.4.) menu to do the partitioning.
11
When the Logical Drive is properly partitioned, go to “View and Edit scsi id
M
ap” (section 2.5.) menu to map the Logical Drive Partitions to LUNs.
87 % Complete
Creating RAID