Asus ROG CROSSHAIR X670E GENE ROG CROSSHAIR X670E Series BIOS manual English - Page 27
Ceiling Low VMax, Auto], Ceiling Hot Temp, Ceiling High VMax, CPU VRM Switching Frequency, VRM
View all Asus ROG CROSSHAIR X670E GENE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
The following items appear only when Voltage Floor Mode is set to [Dynamic]. Ceiling Low VMax The lowest maximum voltage point that maps to Ceiling Hot Temp should the processor temperature move to hotter or equal to Ceiling Hot Temp. Use the or to adjust the value. The values range from 0.000V to 3.000V with an interval of 0.00625V. [Auto] is 1.20V. Configuration options: [Auto] [0.00000] - [3.00000] Ceiling Hot Temp The hottest temperature point that maps to Ceiling Low VMax should the processor temperature move to hotter or equal to Ceiling Hot Temp. Use the or to adjust the value. [Auto] is 88C. Configuration options: [Auto] [0] - [255] Ceiling High VMax The highest maximum voltage point that maps to Ceiling Cold Temp should the processor temperature move to colder or equal to Ceiling Cold Temp. Use the or to adjust the value. The values range from 0.000V to 3.000V with an interval of 0.00625V. [Auto] is 1.450V. Configuration options: [Auto] [0.00000] - [3.00000] Ceiling Hot Temp The coldest temperature point that maps to Ceiling High VMax should the processor temperature move to colder or equal to Ceiling Cold Temp. Use the or to adjust the value. [Auto] is 65C. Configuration options: [Auto] [0] - [255] CPU VRM Switching Frequency Sets the VRM switching frequency. VRM switching frequency affects transient response and VRM component temperatures. Setting a higher switching frequency will result in better transient response at the expense of higher VRM temperatures. Active cooling of the VRM heatsink is recommended when running high CPU voltage and high load-line calibration values. Configuration options: [Auto] [Manual] DO NOT remove the thermal module. The thermal conditions should be monitored. The following item appears only when CPU VRM Switching Frequency is set to [Auto]. VRM Spread Spectrum Reach the magnitude of peak noiseq from the VRM. When enabled, peak noise is reduced. Disable this setting when overclocking. Configuration options: [Auto] [Disabled] [Enabled] ROG CROSSHAIR X670E Series BIOS Manual 27