Asus TR-DLSR TR-DLSR User Manual - Page 22
Installing the CPU and Terminator
View all Asus TR-DLSR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
3. HARDWARE SETUP 3.6.1 Installing the CPU and Terminator Follow these steps to install a CPU. 1. Locate the ZIF socket on the motherboard. 2. Unlock the socket by pressing the lever sideways then lifting it up to a 90°-100° angle. 3. Position the CPU above the socket such that its notched or marked corner matches the socket corner near the end of the lever, while making sure that the CPU is parallel to the socket. 4. Carefuly insert the CPU into the socket until it fits in place. CAUTION! The CPU fits only in one orientation. Do not force the CPU into the socket to prevent bending the pins and damaging the CPU. If the CPU does not fit completely, check its orientation or check for bent pins. 5. When the CPU is in place, press it firmly on the socket while you push down the socket lever to secure the CPU. The lever clicks on the socket indicating that it is locked. 6. Install the CPU terminator the same way as you would install a CPU. The figure on the right shows an installed CPU terminator. 3. H/W SETUP CPU Installation NOTE: Do not forget to set the correct Bus Frequency and Multiple (frequency multiple setting is available only on unlocked processors) for the processor to avoid start-up problems. 22 ASUS TR-DLSR User's Manual