Asus Z170-WS Z170-WS User Guide for English - Page 67
Q-Code Logger, To use Q-Code Logger
View all Asus Z170-WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Chapter 2 6. Wait until the light goes out, indicating that the BIOS updating process is completed. For more BIOS update utilities in BIOS setup, refer to the section 3.11 Updating BIOS in Chapter 3. • Do not unplug portable disk, power system, or press the CLR_CMOS button while BIOS update is ongoing, otherwise update will be interrupted. In case of interruption, please follow the steps again. • If the light flashes for five seconds and turns into a solid light, this means that the BIOS Flashback is not operating properly. This may be caused by improper installation of the USB storage device and filename/file format error. If this scenario happens, please restart the system to turn off the light. • Updating BIOS may have risks. If the BIOS program is damaged during the process and results to the system's failure to boot up, please contact your local ASUS Service Center. Q-Code Logger Q-Code Logger allows you to easily check Q-Code event logs with opening the computer's case. Simply insert a USB storage device to the USB port (the USB port hole marked in green on the I/O shield) then press the USB BIOS Flashback button for three seconds to automatically store the Q-Code event logs. To use Q-Code Logger: 1. Insert the USB storage device to the Q-Code Logger port. 2. Press the Q-Code Logger button at the rear panel for three seconds until the Flashback LED blinks three times, indicating that the Q-Code Logger function is enabled. USB Q-Code Logger button Q-Code Logger does not support NTFS and exFAT32 format. Ensure that your USB flash drive is in single partition and in FAT32 format. Z170-WS 2-13