Asus Z97-DELUXE/USB 3.1NFC&WLC User Guide - Page 106
DIGI+ Power Control, Fixed CPU VRM Switching Frequency KHz [300]
View all Asus Z97-DELUXE/USB 3.1NFC&WLC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
DIGI+ Power Control CPU Load-line Calibration [Auto] Load-line is defined by Intel® specification and affects CPU power voltage. The CPU working voltage decreases proportionally to CPU loading. Higher load-line calibration could get higher voltage and good overclocking performance, but increases the CPU and VRM thermal conditions. Select from levels 1 to 9 to adjust the CPU power voltage from 0% to 125%. Configuration options [Auto] [Level 1] - [Level 9] The actual performance boost may vary depending on your CPU specification. DO NOT remove the thermal module. The thermal conditions should be monitored. CPU VRM Switching Frequency [Auto] This item affects the VRM transient response speed and the component thermal production. Select [Manual] to configure a higher frequency for a quicker transient response speed. Configuration options: [Auto] [Manual] DO NOT remove the thermal module. The thermal conditions should be monitored. The following item appears only when you set the CPU VRM Switching Frequency to [Manual]. Fixed CPU VRM Switching Frequency (KHz) [300] This item allows you to set a higher frequency for a quicker transient response speed. Use the or to adjust the value. The values range from 300 KHz to 500 KHz with an interval of 50 KHz. VRM Spread Spectrum [Disabled] This item allows to enhance the system stability. Configuration options: [Disabled] [Enabled] Active Frequency Mode [Disabled] This item allows to enhance the power saving condition of your system. Configuration options: [Disabled] [Enabled] CPU Power Phase Control [Auto] This item allows you to set the power phase control of the CPU. Configuration options: [Auto] [Standard] [Optimized] [Extreme] [Power Phase Response] DO NOT remove the thermal module when setting this item to [Power Phase Response]. The thermal conditions should be monitored. The following item appears only when you set the CPU Power Phase Control to [Power Phase Response]. Chapter 3 3-22 Chapter 3: BIOS setup