Audiovox FPE1505 User Manual - Page 30

Troubleshooting Before calling for repair service, check the following items for possible remedies to the Symptoms "Ghost" or double images No power No picture Good picture but no sound Check item !This may be caused by obstruction to the antenna due to high rise buildings or hills. Using a highly directional antenna may !Check that the AC power cord is plugged into the mains socket. !Unplug the power cord, wait for 60 seconds. Then re-insert plug !Check antenna connections at the rear of the unit to see if it is properly connected to the unit. !Possible broadcast station trouble. Try another channel. !Adjust the contrast and brightness settings. !Check the Closed Captions control. Some TEXT modes could block the screen. !Select a correct input. !Is a non-compatible signal being input? !Increase the VOLUME. !Check that the unit is not muted. Good sound but poor color Poor picture Horizontal dotted line Television not responding to remote control Snowy picture and noise No stable or not synchronized D-Sub picture No output from one of the speakers Control buttons do not work • Adjust the contrast, color and brightness !Sometimes, poor picture quality occurs when having activated an S-VHS camera or camcorder connected and having connected another peripheral at the same time. In this case, switch off one of the other peripherals. !This may be caused by electrical interference (e.g. hairdryer, nearby neon lights, etc.). !Turn off the equipment. !Check whether the batteries are working. Replace if necessary. !Clean the remote control sensor lens on the unit. !Do not use the remote control under strong or fluorescent !Check the antenna connection. !Check if you have selected the correct D-Sub mode in your !Adjust Balance in the SOUND menu. !Unplug the power cord, wait for some seconds. Then re-plug the power cord and turn on the unit again. + Do not use in hot or cold rooms (locations) • When the unit is used in rooms (locations) with low temperature, the picture may leave trails or appear slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal. • Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near a heater, as this may cause the cabinet to deform and the LCD panel Note: If your problem is not solved, turn your unit off and then on again once. 28