Audiovox VE1040 Owners Guide - Page 9

Under Cabinet Installation FRONT VIEW SIDE VIEW 1) Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an electrical outlet and a TV antenna or cable connection will facilitate a neat, easy installation. Do not mount the VE1040 above a range or oven. Be sure that the location chosen will provide adequate access to the electrical connection on the rear of the unit before continuing. 2) If the location chosen has bottom edge molding it may be necessary to use the mounting spacers provided to effectively lower the VE1040 below or even with the molding. Measure the distance between the bottom and the bottom of the cabinet. For large molding choose a combination of spacers which will allow the VE1040 to be secured to the bottom of the cabinet. 3) Measure the thickness of the bottom of the cabinet or shelf and the spacers chosen. Select the shortest screw length which will secure the VE1040 to the bottom of the cabinet. 5 ) Carefully drill four 1/8" holes at the locations marked above. Place the screws selected through the VE1040 and then through the spacers(if required from the bottom-up). 6) Position the VE1040 and screw it in place using the selected screws. Do not overtighten. 7) Connect your TV antenna or cable system to the antenna connector on the rear of the VE1040. 8) Plug the AC wire into connector on the rear of the VE1040 and then into the wall. 9) If using the speaker phone feature, plug the VE1040 into a phone jack. 10) Attch the FM Dipole Antenna to the FM Antenna screws. 11) Route the wires safely away from heat and moisture sources and secure them in place using the self adhesive wire mounting clip provided. 4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center Punch the four holes indicated on the template and remove the template. -9-