Audiovox VM9311 Instruction Manual - Page 7

VM9311 PREPARATION Congratulations on your purchase of the Jensen VM9311 Mobile Multimedia Receiver. It's a good idea to read all of the instructions before beginning the installation. We recommend having your Jensen VM9311 installed by a reputable installation shop. Features DVD • Compatible formats: DVD-R, DVD-RW, DVD+R, DVD+RW, CD-R, CD-RW, CD-DA, MP3, WMA, SVCD, VCD and MPEG1, MPEG2 and JPEG • Region 1 playback • 16:9 Aspect ratio - Normal / Cinema • Front panel DVD control • High-speed Fast Forward / Fast Rewind 2X, 4X, 8X, 32X • Play, Pause, Stop, Slow • Chapter Up / Down • Wolfson Microelectronics high performance 24-bit, 192 kHz DAC supports 2-channel "Down-Mix" audio modes • 16Mbit high-speed flash memory - 80nS access time MP3/WMA • GIGA MP3 - Store up to 999 MP3 files on a DVD • ID3-tag compatible • Direct track access • Play, Pause, Stop, Track Up / Down • 100 second (MP3), 200 second (WMA) ESP - Electronic Skip Protection CD • CD-text compatible • 4 second ESP - Electronic Skip Protection AM/FM Tuner • US/Euro/Latin/Asia Tuner • 30 Station presets (18FM/12AM) • JENSEN Plus Tuner II Outboard Media Module • XM Radio and iPod XM Ready • Requires Optional Terk XMD1000 Tuner Box • Requires Optional Terk XMDJEN100 or Jensen JXMC XM Cables • Advanced display shows the artist, song title, and XM channel and category at a glance • Direct Channel entry Made for iPod • Controls and charges all iPod's except "Shuffle" • Displays all text information including category, track name, artist and channel number Chassis • 7-inch TFT active-matrix LCD, 336, 960 pixels (1440W X 234H) • Full automatic motorized TFT LCD flip-out and up • 16-step TFT LCD tilt adjustment • Beep Tone confirmation • Heat management system - Incorporates forced air- cooling to keep the chip-sets operating at nominal temperatures • Heavy duty galvanized chassis General • Full function infrared remote control • 1 NTSC composite video output for additional screens • OSD- On Screen Display menu control • High performance audio processor • Electronic volume, bass, treble, balance and fader • Bass center frequency adjustment - 60, 80, 100, 130, 150 and 200Hz • Bass Q factor - 1.0, 1.25, 1.5 and 2.0 • Treble center frequency adjustment - 10, 12.5, 15 and 17kHz • Subwoofer crossover - 80, 120 and 160Hz • Subwoofer Phase - 0, 180 degrees • Subwoofer level - variable • 100-ohm low impedance preamp outputs - all channels • 5V Peak / 2V RMS RCA outputs - all channels • 1-pair Front RCA outputs • 1-pair Rear RCA outputs • Single Subwoofer RCA output • 1-pair Auxiliary RCA A/V inputs • Flex fader • Front panel (when screen is closed) high contrast LCD • Rotary encoder audio control • Joystick menu navigation Tools and Supplies You will need these tools and supplies to install your VM9311: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections • 16 - 18 gauge speaker wire WARNING! Only connect the unit to a12-volt power supply with proper grounding. WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions. WARNING! To reduce the risk of a traffic accident (except when using for rear view video camera) never use the video display function while driving the vehicle. This is a violation of federal law. WARNING! Never disassemble or adjust the unit. WARNING! To prevent injury from shock or fire, never expose this unit to moisture or water. WARNING! Never use irregular discs. WARNING! To prevent damage to the mechanism inside this unit, avoid impact to the TFT monitor. WARNING! Using an improper fuse may cause damage to the unit and result in a fire. WARNING! To prevent damage to the screen, avoid touching it with your fingers or other objects. WARNING! The monitor employs an automatic motorized mechanism. To prevent damage to the core mechanism, please do not push, pull or swivel the monitor manually. Optional Accessories iAUX3 READY (Sold Separately) • Can connect to any portable media device or multimedia device using a standard 3.5mm plug. • Converts 3.5mm auxiliary input to RCA stereo outputs for easy connection to the radio's auxiliary inputs. 1