Avanti ER2002CSS Instruction Manual - Page 14

3-Wire Power Cord Installation • Remove the Terminal Block Access Plate on the back of range by removing the 2 fixing screws. • Assemble the strain relief in the hole on bracket. • Insert the powCeurt GcorrodunthdroSutgrhapthe strain relief and tighten. • Allow enough slaTcekrtmo ienaaslilBy laotctakch the cord terminals to the terminal blockN. eutral Wire • Remove the 3 wire terminal nuts and washers from the terminal blocGk.rounding Wire • Plug the terminal holes of power cord. The neutral or ground wire of the power cord must be connected to the neutral terminaPl olowcaetreWd iinretshe center of terminal block. The power lPeaodwsemr Cusotrdbe connected to the outside terminals. • Plug washers and tightenBnruatcskseetcurely. • Assemble the Terminal Block Access Plate. Screws Grounding Screw Terminal Block Access Plate Cut Ground Strap Terminal Block Neutral Wire Power Wires Power Cord Bracket 4-Wire Power Cord Installation • Remove the Terminal Block Access Plate on the back of range by removing the 2 fixing screws. Cut Ground Strap Grounding Screw • Assemble the strain relief in the hole on bracket. • Insert the power cord through the strain relief and Terminal Block Neutral Wire tighten. Grounding Wire • Allow enough slack to easily attach the cord terminals to the terminal block. • Remove the 3 wire terminal nuts and washers from the terminal block. Power Wires Power Cord Bracket • Remove the ground strap from the frame of range and terminal by removing its screw and cutting is as shown. • Plug the terminal holes of power cord. The neutral wire of the power cord must be connected to the neutral terminal located in the center of terminal block. The ground wire of the power supply cord must be attached to the frame of range by using the green colored grounding screw. The power leads must be connected to the outside terminals. • Plug washers and tighten nuts securely. • Assemble the Terminal Block Access Plate.  LEVELING THE RANGE The range must be level to obtain proper operating. The four screws type leveling legs located on the corners at the bottom of range should be adjusted by turning them clockwise to make the range higher or counter-clockwise to lower the range until the range is level. Use a level on surface units to check the leveling of the range. 14