Behringer EURODESK SX4882 Manual - Page 14

14 EURODESK SX4882 User Manual Auxiliary returns All six stereo pairs, to be located immediately below the aux sends, are on unbalanced 1/4" jacks and operate at 0 dBu. Fig. 7.3: Auxiliary returns Subgroup inserts Unbalanced send and return from a single stereo jack socket, wired tip = out, ring = in and sleeve = ground/screen. Main inserts As above, but for the main mix. Stereo outputs The control room output (monitors) main mix, MIX-B and studio output are all on a pair of unbalanced 1/4" jacks, nominal output level +4 dBu. The main mix is also available as a fully balanced pair. Phones 1/2 These are on stereo jacks, wired tip = left signal, ring = right signal and sleeve = ground/screen (see section 6.4 "Headphones"). Meter/analyzer out Unbalanced jacks at +4 dBu for use with external measuring equipment, e.g. the built-in real-time analyzer of our BEHRINGER ULTRACURVE PRO DEQ2496 (signal = master LED meters). Master balanced outputs Balanced XLR for connecting to the mastering recorder. Wired pin 1 ground/ screen, pin 2 hot and pin 3 cold. Maximum level is +28 dBu. Fig. 7.4: Subgroup inserts 2-track in/out RCA sockets for use with tape recorders, etc., signal = main mix, wired center post = signal (+ve) and sleeve = ground/screen. Fig. 7.7: Main balanced outputs Fig. 7.5: 2-track in/out 2-track/external inputs Two additional stereo inputs, this time on unbalanced 1/4" jacks, wired tip = signal (+ve) and sleeve = ground/screen. Fig. 7.6: Additional connectors behringer.com Fig. 7.8: A and B-channel input section