Behringer ULTRALINK UL2000M Manual - Page 11
Deactivating LOCK, 2.7 PRESET, Factory presets Presets 2, 3 and 4, User preset Preset 1, Loading
View all Behringer ULTRALINK UL2000M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ULTRALINK UL2000M Deactivating LOCK 1. Press the SET button. LOC ON is shown in the display. 2. Press the UP or DOWN button once to select LOCOFF. 3. Press the SET button confirm, hence deactivating the keylock function. The procedure is now over, and the basic settings are shown in the display again. 2.2.7 PRESET The ULR2000 lets you work with 4 presets, each with 8 channels. Factory presets (Presets 2, 3 and 4) In the ULR2000, there are 3 factory presets (each with 8 interference-free channels). That means that all 8 channels of one preset can run simultaneously with 8 different transmitters and receivers without causing mutual interference. The channels in the 3 factory presets are all assigned to different frequencies. This way, you can always select a frequency range that assures the best signal transmission. The following table shows which frequencies are stored in the factory presets. CHANNEL 1 2 3 4 5 6 7 8 PRESET 2 798,700 MHz 799,950 MHz 800,650 MHz 801,050 MHz 802,850 MHz 804,500 MHz 805,350 MHz 805,900 MHz Tolerance 0.005% PRESET 3 798,400 MHz 798,950 MHz 799,800 MHz 801,450 MHz 803,250 MHz 803,650 MHz 804,350 MHz 805,600 MHz PRESET 4 798,100 MHz 798,650 MHz 799,500 MHz 801,150 MHz 802,950 MHz 803,350 MHz 804,050 MHz 805,300 MHz Table 2.1: Factory preset frequencies (presets 2,3 and 4) User preset (Preset 1) Preset 1 is meant for the user. Frequencies of your own choice can be stored in the 8 storage slots of this preset. If you have not stored any of your own frequencies, the frequencies stored in the user preset (Preset 1) are identical to the frequencies stored in Preset 3. Loading a preset 1. Press the SET button to get to the menu. 2. Press the DOWN button once to get to PRESET. 3. Press the SET button again to get to the PRESET submenu. The display shows the currently active preset. 4. Press the UP and DOWN buttons to select the desired preset. The display shows PSET 1 (2, 3 or 4). 5. Press the SET button to load up the preset you selected. The procedure is now over, and the basic setting is shown in the display again. 2. ULR2000 RECEIVER 11