Beko ASGN542 User Manual - Page 13

Installation 4. Attach the connector into the tap adaptor and tighten by hand / tool. 2. Connect the other end of the water hose to the water pump by pushing the hose into the pump's hose inlet. 5. To avoid damaging, shifting or accidentally 3. Place and fasten the pump hose inside the disconnecting the hose, use the clips provided carboy. to fix the water hose appropriately. A WARNING: After turning the tap on, make sure there is no water leak on either end of the water hose. In case of leakage, turn the valve off and tighten all connections using a pipe wrench or pliers. 3.8. For products using water carboy (Optional) To use a carboy for the product's water connection, the water pump recommended by the authorized service must be used. 1. Connect one end of the water hose provided with the pump to the product (see 3.6) and follow the instructions below. 4. Once the connection is established, plug in and start the water pump. C Please wait 2-3 minutes after starting the pump to achieve the desired efficiency. C See also the pump's user guide for water connection. C When using carboy, water filter is not required. 3.9 Water filter (Optional) The product may have internal or external filter, depending on the model. To attach the water filter, follow the instructions below. 12 / 42 EN Refrigerator / User Guide