Beko ASGN542 User Manual - Page 31
Using the product, 6. Taking ice / water, 7. Drip tray
View all Beko ASGN542 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Using the product 5.6. Taking ice / water • The water may be cloudy during first use of (Optional) the filter; do not consume the first 10 glasses To take water ( ) / ice cube ( ) / fragmented of water. ice ( ), use the display to select the respective • You must wait approximately 12 hours to get option. Take water/ice by pushing the trigger cold water after first installation. on the water fountain forward. When switching • The product's water system is designed between ice cube ( ) / fragmented ice ( ) for clean water only. Do not use any other options, the previous ice type may be discharged a beverages. few more times. • It is recommended to disconnect the water supply if the product will not be used for long periods during vacation etc. • If the water fountain is not used for a long time, the first 1-2 glasses of water received may be warm. • You must wait approximately 12 hours before taking ice from the ice / water fountain for the first time. The fountain may not discharge ice if there is insufficient ice in the ice box. • The 30 pieces of ice cubes (3-4 Litres) taken after first operating should not be used. • In case of power blackout or temporary malfunction, the ice may partly melt and refreeze. This will cause the ice pieces to merge with each other. In case of extended power blackouts or malfunction, the ice may melt and leak out. If you experience this problem, remove the ice in the ice box and clean the box. 5.7. Drip tray (optional) The water dripping from the water fountain accumulates on the drip tray; no water drainage is available. Pull the drip tray out or push on the edges to remove the tray. You may then discharge the water inside the drip tray. A WARNING: The product's water system should be connected to cold water line only. Do not connect to hot water line. • The product may not discharge water during first operation. This is caused by the air in the system. The air in the system must be discharged. To do this, push the water fountain trigger for 1-2 minutes until the fountain discharges water. The initial water flow may be irregular. The water will flow normally once the air in the system is discharged. 30 / 42 EN Refrigerator / User Guide