Beko ASGN542 User Manual - Page 5

Safety and environment instructions Professional plumbers is you Warning! This appliance must are not sure that there is no be earthed water hammer effect in your If the fitted moulded plug is not installation. suitable for your socket, then the • Do not install on the hot water plug should be cut off and an inlet. Take precautions against appropriate plug fitted. Destroy of the risk of freezing of the the old plug which is cut off as a hoses. Water temperature plug with bared cord could cause operating interval shall be 33°F a shock hazard if inserted into a (0.6°C) minimum and 100°F socket elsewhere in the house. (38°C) maximum. The moulded plug on this • Use drinking water only. appliance incorporates a 13 A Electrical requirements fuse. Should the fuse need to be Before you insert the plug into replaced an ASTABEAB approved the wall socket make sure that BS 1362 fuse of the same rating the voltage and the frequency must be used. Do not forget to shown on the rating plate inside refit the fuse cover. In the event the appliance corresponds to your of losing the fuse cover the electricity supply. plug must not be used until a Rating label is on the left hand replacement fuse cover has been side of fridge inner liner. fitted. We recommend that this Colour of the replacement fuse appliance be connected to the cover must be the same colour as mains supply via a suitable that visible on the pin face of the switched and fused socket. The plug. Fuse covers are available appliance must be positioned so from any good electrical store. that the plug is accessible. Should the mains lead of the appliance become damaged or should it need Replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a Beko authorised service agent. 4 / 42 EN Refrigerator / User Guide