Beko DC7110 User Manual - Page 16

16

EN

Auxiliary function

Low temperature

This function allows for drying at lower

temperatures and therefore saves energy.

Warning LED will light up when you select the

function.

C

You must use this function when you dry

your synthetic or delicate laundry.

Warning indicators

C

Warning indicators may differ according to the

model of your dryer.

Filter cleaning

A warning light will turn on to remind filter

cleaning after the programme finishes.

C

If the filter cleaning warning light lights up

continuously, please refer to, “Suggested

solutions for problems”.

Water tank

A

Warning LED will light up at the end of

the programme or when the tank is full

with water. The machine stops operating

when this warning LED lights up during a

programme running.

To restart the machine,

please drain the water in the water tank.

Press “Start/Pause/Cancel” button to start

the programme after you have emptied the

water tank. The warning LED goes off and

the programme resumes operating.

Starting the programme

1. Press “Start/Pause/Cancel” button to start

the programme.

2. Light of the “Start/Pause/Cancel” button will

turn on to indicate that the programme has

started.

Timer follow-up indicator

One of the LEDs is on as far as programme runs

and shows the approximate remaining time.

Changing the programme after the

programme has started

You can use this feature to dry your laundry in

a different programme after your machine has

started to run.

For example;

Press and hold the “Start/Pause/Cancel” button

for about 3 seconds to select “90” minutes

programme instead of “60” minutes program.

Select the “90” minutes programme by rotating

the program knob.

Press “Start/Pause/Cancel” button to start the

programme.

C

The program which is selected first will go

on even if the programme selection button

is moved and another programme mode

is selected while the machine is operating.

You must cancel the ongoing programme in

order to change the drying programme. (See,

Ending the programme through canceling)

Adding/removing laundry in standby

mode

In order to add or take out laundry after the

start-up of the programme;

1. Press the “Start/Pause/Cancel” button to

switch the machine to “Pause” mode. Drying

process will stop.

2. Open the door at Pause position and close it

again after adding or taking out laundry.

3. Press “Start/Pause/Cancel” button to start the

programme.

C

Any laundry added after the drying process

was started may cause the already dried

clothes in the machine intermingle with wet

clothes and the result will be wet laundry after

the drying process is over.

Child-proof lock

There is a childproof lock to prevent any

programme interruption due to the pressing of

keys while the programme is on. The loading

door and all keys except the “On/Off” key on the

panel are deactivated when the child-proof lock

is active.

In order to activate the childproof lock, press

on the “Start/Pause/Cancel” and “Low

temperature” buttons simultaneously for 3

seconds.

To start a new programme after the programme

is over or to interrupt the programme, the

childproof lock should be deactivated. To

deactivate the childproof lock, press the same

buttons for 3 sec.

C

One of the LEDs on the programme follow-up

indicator starts flashing when the child-proof

lock is activated.

C

Child-proof lock is deactivated when the

machine is restarted by pressing the On/Off

button.

Ending the programme through

canceling

The programme which is selected first will keep

on going even if the position of the programme

selection button is changed. A new programme

can be selected and started after “Programme

cancel” is activated in order to change the drying

programme.

To can cel any selected programme;

• Press “Start/Pause/Cancel” button for about

a duration of 3 seconds. The “Filter cleaning”

Beko DC7110 User Manual - Page 16

programme has started

Page 16 highlights