Beko DC7110 User Manual - Page 6

2 Important safety information This section includes safety information that will or explosive materials as well as the items help protection from risks of personal injuries that are contaminated or spotted with such or materialistic damages. Failure to follow materials should not be dried in the product these instructions shall cause any warranty and since they emit flammable or explosive vapor. reliability commitment to become void. • Do not dry items cleaned with industrial General safety chemicals in the dryer. • Do not dry unwashed items in the dryer. • Never place the machine on a carpet-covered • Items soiled with cooking oils, acetone, floor, otherwise, lack of airflow beneath alcohol, fuel oil, kerosene, stain remover, the machine may cause electrical parts to turpentine, paraffin and paraffin removers overheat. This will cause problems with your must be washed in hot water with plenty of machine. detergent before being dried in the dryer. • If the power cable or mains plug is damaged, • Garments or pillows bolstered with rubber you must call Authorised Service Agent for foam (latex foam), shower bonnets, water repair. resistant textiles, materials with rubber • The product should not be plugged in during reinforcement and rubber foam pads should installation, maintenance and repair works. not be dried in the dryer. Such works should always be made by the • Do not use fabric softeners and anti-static technical service. Manufacturer shall not products unless they are recommended by be held responsible for damages arising the manufacturers of the fabric softener or from processes carried out by unauthorised the product. persons. • This product must be grounded. Grounding • Connect the product to a grounded outlet installation decreases the risk of electric protected by a fuse of suitable capacity as shock by opening a path with low resistance stated in the technical specifications table. for the electricity flow in case of a malfunction • Operate your product at temperatures or failure. Power cable of this product is between +5°C and +35°C. equipped with a conductor and a grounding • Do not use electrical devices in the product. plug that allows for grounding the product. • Do not connect the air exit of the product This plug must be installed appropriately and to the chimney holes which are used for the inserted into a socket which is grounded exhaust fumes of the devices operating with in accordance with the local laws and gas or other types of fuel. regulations. • You must provide enough ventilation in • Do not install the product behind a door with order to prevent gases exiting from devices a lock, sliding door or a door that has a hinge operating with other types of fuels including against the hinge of the dryer. the naked flame from accumulating in the • Do not install or leave this product in room due to the back fire effect. places where it will be exposed to outdoor • Always clean the lint filter before or after each conditions. loading. • Do not tamper with the controls. • Never operate your dryer without the lint filter • Do not perform any repair or part replacing installed. procedures on the product even if you know • Do not allow fibre, dust and dirt accumulation or have the ability to perform unless it is around the exhaust exit and at adjacent clearly suggested in the operating instructions areas. or the published service manual. • Power cable plug must be within easy reach • Inside and exhaust duct of the product must after installation. be cleaned by the qualified service personnel • Do not use extension cords, multi-plugs periodically. or adaptors to connect the dryer to power • Wrong connection of grounding conductor supply in order to decrease the risk of electric of the product can cause electric shock. If shock. you have any suspect about the grounding • Do not make any changes on the plug connection, have it checked by a qualified supplied with the product. If it is not electrician, service representative or service compatible with the socket, have a qualified personnel. electrician change the socket with a suitable • Do not reach into the machine when the one. drum is spinning. • Items cleaned or washed with gasoil/fuel oil, • Unplug the machine when it is not in use. dry-laundry solvents and other combustible • Never wash down the appliance with water! 6 EN