Beko DC7110 User Manual - Page 8

3 Installation A Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products will cause risks for your safety. Appropriate installation location • Install the product in an environment which has no risk of freezing and is in a stable and level position. • Operate your product in a well ventilated, dust-free environment. • Do not block the air ducts in front of and under the product with materials such as long pile rugs and wooden plinths. • Do not place your product on a long pile rug or on similar surfaces. • Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product. • Once the product is installed, it should stay at the same place where its connections have been made. When installing the product, make sure that the rear wall of it does not touch anywhere (tap, socket, etc.) and also pay attention to install the product BaDt oa place where it will stay permanently. not place the product on top of the power cable. • Keep at least 1.5 cm distance to walls of other furniture. Removing the transportation safety aAssReemmobvley the transportation safety assembly before using the product for the first time. 1. Open the loading door. 2. There is a nylon bag inside the drum that contains a piece of styrofoam. Hold it from its section marked with XX. 3. Pull the nylon towards yourself and remove the transportation safety assembly. AMake sure that you have removed the transportation safety assembly (nylon+styrofoam pieces) before using the product for the first time. Do not leave any items inside the drum. Under counter installation • The product should never be operated without the top trim. • Leave at least 3 cm of space between the side and rear walls of the product and the walls of the counter/cupboard when installing your product under a counter or in a cupboard. Mounting over a washing machine • A fitting device should be used between the two machines when installing above a washing machine. The bracket must be installed by the Authorised Service Agent. • Place the product on a firm floor. If it will be placed on top of a washing machine, the approximate weight of both machines may reach 180 kg when they are full. Therefore, the floor must be capable of carrying the load on it! . Adjusting the feet In order to ensure that your machine operates more silently and vibration-free, it must stand level and balanced on its feet. Balance the machine by adjusting the feet. Rotate the feet to adjust until the machine stands level and firmly. C Never unscrew the adjustable feet from their housings. First use • To have the product ready for operation before calling the authorised service agent, make sure that its location and power supply installations are appropriate. If they are not, call a qualified electrician to have any necessary arrangements carried out. • Make sure that the power connections of the product are in accordance with the instructions given in relevant chapters of this manual. 8 EN