Beko DFS28R20 User Manual - Page 10

3 Installation To make the product ready for use, make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorised Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. C Preparation of the location and electrical, tap water and waste water installations at the place of installation is under customer's responsibility. B Manufacturer shall not be held responsible for damages arising from processes carried out by unauthorised persons. A Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. C Make sure that the water inlet and discharge hoses are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures. When placing the product, pay attention not to damage the floor, walls, piping, etc. Do not hold the product from its door or panel to move it. Appropriate installation location •• Place the product on a solid and flat floor that has sufficient load carrying capacity! The product must be installed on a flat surface in order for the door to be closed comfortably and securely. •• Do not install the product at places Dishwasher / User's Manual where temperature may fall below 0ºC. •• Place the product on a rigid floor. Do not place it on a long pile rug or similar surfaces. B Ensure the power cable does not get trapped under the product. •• Make sure that you select a location that will allow you to load and unload the dishes in a fast and comfortable manner. •• Install the product in a place close to the tap and the drain. Select the installation location by considering that it will not be changed after the connections are made. Connecting water supply •• Do not use old or used water inlet hose on the new product. Use the new water inlet hose supplied with the product. •• Connect the water inlet hose directly to the water tap. Pressure coming from the tap should be minimum 0.3 and maximum 10 bars. If the water pressure exceeds 10 bars, a pressure relief valve should be installed in between. •• Open the tap completely after making the connections to check for water leaks. A For your safety, close the water inlet tap completely after the washing programme is over. Connection to the drain Water discharge hose can directly be connected to the drain hole or sink's drainage. The length of this connection must be min. 50 cm and max. 100 cm from 9/39 EN