Beko DIN48430 Owners Manual - Page 33

Operating the product Adjusting the amount of rinse aid 1. After switching on your machine, press the Menu key for 1 second. 2. Using keys, proceed to "P:" on the display. 3. Set to the appropriate level with the Selection key. 4. Press the Menu key to exit the settings menu. Your setting will be saved automatically. No rinse aid dispensed in P:0 wash position. 1 dose of rinse aid is dispensed in P:1 position. 2 doses of rinse aid are dispensed in P:2 position. 3 doses of rinse aid are dispensed in P:3 position. 4 doses of rinse aid are dispensed in P:4 position. End of programme C When the programme you have selected comes to an end, an audible warning signal will warn you to turn off your machine. This audible signal will warn you with certain intervals before it turns off. End of Programme indicator will light up when the washing programme is over. 1. Open the door of the machine. 2. Press On/Off key to turn off your machine. 3. Close the tap. 4. Unplug the machine from the socket. C For energy saving, the machine is automatically turned off following the completion of the programme or if the programme is not started. C Leave your dishes in the machine for about 15 minutes to allow them cool down after they are washed. Your dishes will dry in a shorter time if you leave the door of your machine ajar during this period. This process will increase the drying effectiveness of your machine. Water cut-off warning If mains water is cut or water inlet tap is turned off the machine cannot take water in and E:02 icon will flash on the programme indicator. As long as the problem continues, washing programme is paused and the water inlet is checked regularly by the machine; when the water is restored E:02 icon will disappear after a while and the washing programme resumes. Overflowing warning If the machine intakes too much water or there is leakage at any of the components then the machine will detect this and E:01 icon will flash on the Programme indicator. As long as the overflowing continues safety algorithm will be active and try to discharge the water. If overflowing stops and safety is assured, E:01 icon will disappear. If E:01 does not disappear, there is a permanent fault. In this case the authorised service should be contacted. Dishwasher / User's Manual 31/46 EN