Beko DSV64 User Manual - Page 7

Clothes that are washed inadequately may ignite on their own and even may ignite after drying ends. • You must provide enough ventilation in order to prevent gases exiting from devices operating with other types of fuels including the naked flame from accumulating in the room due to the back fire effect. A Clothing that contains metal reinforcements should not be dried in the dryer. Dryer may be damaged if metal reinforcements come loose and break off during drying. C Use softeners and similar products in accordance with the instructions of their manufacturers. C Always clean the lint filter before or after each loading. Never operate the dryer without the lint filter installed. • Never attempt to repair the dryer by yourself. Do not perform any repair or replacement procedures on the product even if you know or have the ability to perform the required procedure unless it is clearly suggested in the operating instructions or the published service manual. Otherwise, you will be putting your life and others' lives in danger. • There must not be a lockable, sliding or hinged door that may block the opening of the loading door in the place where your dryer is to be installed. • Install your dryer in a suitable place that is dry, well ventilated and unlikely to get below 5 degrees Centigrade. • Make sure that pets do not enter the dryer. Check the inside of the dryer before operating it. • Do not lean on the loading door of your dryer when it is open, otherwise it may fall over. • The lint must not be allowed to accumulate around the tumble dryer. Dryer / User Manual 7 / EN