Beko HQC63402E User Manual - Page 10

Installation and connection • The product must be installed in accordance with all local gas and electrical regulations. Do not install the hob on places with sharp edges or corners. There is the risk of breaking for glass ceramic surface! Electrical connection Connect the product to a grounded outlet/line protected by a fuse of suitable capacity as stated in the "Technical specifications" table. Have the grounding installation made by a qualified electrician while using the product with or without a transformer. Our company shall not be liable for any damages that will arise due to using the product without a grounding installation in accordance with the local regulations. DANGER: The product must be connected to the mains supply only by an authorised and qualified person. Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. DANGER: • The power cable must not be clamped, bent or trapped or come into contact with hot parts of the product. A damaged power cable must be replaced by a qualified electrician. Otherwise, there is risk of electric shock, short circuit or fire! • Connection must comply with national regulations. • The mains supply data must correspond to the data specified on the type label of the product. Type label is at the rear housing of the product. • Power cable of your product must comply with the values in "Technical specifications" table. DANGER: Before starting any work on the electrical nstallation, disconnect the product from the mains supply. There is the risk of electric shock! Connecting the power cable 1. If it is not possible to disconnect all poles in the supply power, a disconnection unit with at least 3 mm contact clearance (fuses, line safety switches, contactors) must be connected and all the poles of this disconnection unit must be adjacent to (not above) the product in accordance with IEE directives. Failure to obey this instruction may 10/EN cause operational problems and invalidate the product warranty. Additional protection by a residual current circuit breaker is recommended. f a cable is supplied with the product: 5,3,5 ronf' 880416M- .32,3.24,0 3e At- 220.210Yel- 2. For single-phase connection, connect the wires as identified below: • Brown/Black cable = L (Phase) • Blue/Grey cable = N (Neutral) • Green/yellow cable = (E) - (Ground) >> or • Grey/Black cable = L (Phase) • Blue/Brown cable = N (Neutral) • Green/yellow cable = (E) (Ground) 3. For double-phase connection, connect the wires as identified below: • Brown cable = L1 (Phase 1) • Black cable = L2 (Phase 2) • Blue/Grey cable = N (Neutral) • Green/yellow cable = (E) = (Ground) >> or • Black cable = L1 (Phase 1) • Grey cable = L2 (Phase 2) • Blue/Brown cable = N (Neutral) • Green/yellow cable = (E)±- (Ground) Installing the product 1. Turning the hob upside down, place it on a flat surface. 2. The sealing gasket provided in the package must be applied on the lower casing bend around the hob as shown in the figure, during installation of the hob.