Beko KDG653 User Manual - Page 18
conversion
![]() |
View all Beko KDG653 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
DANGER: The gas hose must not be clamped, bent or trapped or come into contact with hot parts of the product. There is the risk of explosion due to damaged gas hose. • Push the product towards the kitchen wall. • Hook safety chain. • Adjusting the feet of oven Vibrations during use may cause cooking vessels to move. This dangerous situation can be avoided if the product is level and balanced. For your own safety please ensure the product is level by adjusting the four feet at the bottom by turning left or right and align level with the work top. Final check 1. Check electrical functions. 2. Open gas supply. 3. Check gas installations for secure fitting and tightness. 4. Ignite burners and check appearance of the flame. Flame must be blue and have a regular shape. If the flame is yellowish, check if the burner cap is seated securely or clean the burner. Gas conversion DANGER: • Before starting any work on the gas installation, disconnect the gas supply. There is the risk of explosion! In order to change your appliance's gas type, change all injectors and make flame adjustment for all valves at reduced flow rate position. • Gas conversion must only be carried out by a Gas Safe registered installer or service agent. Exchange of injector for the burners 1. Take off burner cap and burner body. 2. Unscrew injectors by turning the counter- clockwise. 3. Fit new injectors. 18/EN 4. Check all connections for secure fitting and tightness. New injectors have their position marked on their packing or injector table on Injector table, page 13 can be referred to. 2 --1.1 3 4 1 Flame failure device 2 Spark plug 3 Injector 4 Burner Unless there is an abnormal condition, do not attempt to remove the gas burner taps. ou must call an Authorised service agent if it is necessary to change the taps. Reduced gas flow rate setting for hob taps 1. Ignite the burner that is to be adjusted and turn the knob to the reduced position. 2. Remove the knob from the gas tap. 3. Use an appropriately sized screwdriver to adjust the flow rate adjustment screw. For LPG (Butane - Propane) turn the screw clockwise. For the natural gas, you should turn the screw counter-clockwiseonce. » The normal length of a straight flame in the reduced position should be 6-7 mm. 4. If the flame is higher than the desired position, turn the screw clockwise. If it is smaller turn anticlockwise. 5. For the last control, bring the burner both to high-flame and reduced positions and check whether the flame is on or off. Depending on the type of gas tap used in your appliance the adjustment screw position may vary.
![](/manual_guide/products/beko-kdg653-user-manual-23ae8ba/18.png)