Beko KDG653 User Manual - Page 20
important.
![]() |
View all Beko KDG653 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
2 7 6 54 1 Oven burner 2 Screw (3 pieces) 3 Cut-off valve 4 Injector holder 5 Injector 6 Oven burner holder 7 Clips 3 7. Mount the oven burner (1) and holder (6) as a group to the cavity by screwing 3 screws (2). Reduced flow adjustment for the gas oven For the appropriate functioning of the oven rechecking the by-pass adjustment is extremely important. In order to provide maximum security to the user these operations have to be done with care. 1. Ignite the burner that is to be adjusted and turn the knob to the high flame position. 2. Close the oven door and wait for 10 to 15 minutes until the oven becomes ready for adjustment. 3. Take out the knob 4. After 15 minutes, adjust the oven to the lowest flame ,osition. 400 00 7 6 4 1. Unscrew 3 screws (2) to remove oven burner (1) and oven burner holder (7). 2. Gently pull up burner and holder in "A" direction- be careful with gas connection tube and thermocouple. 3. Push the clips (7) in "B" direction to disassemble oven burner (1) and its holder(6). 4. Unscrew the injector (5) and replace it with appropriate injector, see, Injector table, page 13 injector table. 5. Conduct the leakage control after replacing the injector. 6. Assemble the oven burner (1) to its holder (6) by pushing the burner on the clips (7) in "B" direction. 5. Set the flame length to 2 to 3 mm by means of the screw 1 on the oven tap. Turning in clockwise direction reduces the flame, turning counter-clockwise increases the flame. If gas flow rate of oven cannot be set with removing knob, please remove the needed oven parts (control panel, burner plate etc.) and then set the gas flow rate of oven. If the temperature of the oven increases unintendedly, turn off the oven and call the authorised service agent to have oven thermostat repaired. 20/EN
![](/manual_guide/products/beko-kdg653-user-manual-23ae8ba/20.png)