Belkin F1DP101M User Manual - Page 28

Step 6, Serial Settings

Get Belkin F1DP101M PDF manuals and user guides View all Belkin F1DP101M manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Remote Installation Step 6 Serial Settings The SMB Remote IP Device supports one serial device, which can be attached using the included serial cable. The serial device can be accessed remotely via the IP Device's VT100 serial terminal emulation. If you have a serial device connected to the Switch, such as a power distribution unit (PDU), you must configure the serial (RS232) settings. To open the Serial-Settings page, click "Serial Settings" under "Administration" in the far-left menu (see Fig. 5). Fig. 5 Serial-Settings Page To configure your serial device: 1. Type in the name of the serial device. 2. Using the drop-down menus, select the correct baud rate, parity, and data-and stop-bit parameters for the device. 3. Check the "Show" box. This will make the serial device appear in the list of servers and devices that can be accessed through the quick-access toolbar. 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
25
Remote Installation
Step 6
Serial Settings
The SMB Remote IP Device supports one serial device, which can be attached
using the included serial cable. The serial device can be accessed remotely via
the IP Device’s VT100 serial terminal emulation.
If you have a serial device connected to the Switch, such as a power distribution
unit (PDU), you must configure the serial (RS232) settings. To open the
Serial-Settings page, click “Serial Settings” under “Administration” in the far-left
menu (see Fig. 5).
Fig. 5 Serial-Settings Page
To configure your serial device:
1.
Type in the name of the serial device.
2.
Using the drop-down menus, select the correct baud rate, parity, and
data-and stop-bit parameters for the device.
3.
Check the “Show” box. This will make the serial device appear in the list of
servers and devices that can be accessed through the quick-access toolbar.