Beltronics RX45 Owner's Manual - Page 14
Troubleshooting
UPC - 065789277098
View all Beltronics RX45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Troubleshooting Problem RX45 beeps briefly at the same location every day,but no radar source is in sight. RX45 does not seem sensitive to radar or laser. RX45 did not alert when a police car was in view. RX45 did not provide a Safety signal while within range of an emergency vehicle. The RX45's audible alerts are less loud after the first few alerts. The RX45's power-on sequence reoccurs while you are driving. Your 14-year old son has changed all 5 of the Preferences options. RX45 will not turn on. The RX45's display feels very warm. Solution • An X-band motion sensor or intrusion alarm is located within range of your route.With time,you will learn predictable patterns of these signals. • RX45 may be in Auto NoX. • VASCAR, (Visual Average Speed Computer and Recorder) a stopwatch method of speed detection, may be in use. • Officer may not have radar or laser unit turned on. • Safety transmitters may not be commonly used in your area. • RX45 is in AutoMute Mode. See page 4 for details. • A loose power connection can cause RX45 to be briefly disconnected, and will retrigger the power-on sequence. You can return all of the programming options to the factory defaults by holding down the BRT and SENS buttons while you turn RX45 on. • Check that volume control is ON. • Check that vehicle ignition is ON. • Check all connections. • It is normal for the RX45 to feel warm. 24 Explanation of Displays Check Receiver Wiring There is a problem with the front receiver (it could be an unplugged connection, damaged wiring, or a problem within the front receiver itself). The RX45 will continue to display this message, and will not operate until the problem has been repaired PilotHWY One of the many options in Preferences (pages 12-15) WorkZone One of the many Safety Radar messages (pages 22-23) Caution RX45 has detected a Safety Radar Signal, but the signal isn't yet strong enough to decode the specific safety message (page 22-23) X2, or K2, RX45 has been programmed in the ThreatDisplay Mode (pages 10-11) or Ka2 etc. RCVR err RX45 has failed to calibrate. Contact you Dealer for repair 25