Beltronics RX45 Owner's Manual - Page 8

How to use Preferences There are 5 user-selectable programming An example options on the RX45.This allows you to set Here's how you would turn the RX45's it up the way you prefer. AutoMute feature off. To access Programming, simply press the buttons that are normally used for 1 Enter Programming by holding both brightness (BRT) and sensitivity (SENS) at buttons down for 2 seconds. The RX45 will the same time. Once you access beep and display Program. Programming, the BRT button is used to review (RVW) the categories and the SENS 2 Then hold the RVW button down. button is used to change (CHG) items The RX45 will scroll through the categories, within the category.Pages 14-15 explain each option in more detail. starting with Pilot (Pilot), then Signal Strength Meter (Meter), then AutoMute How to use Preferences 1 To enter Programming, press both (aMute). 3 Release the RVW button when the buttons and hold for 2 seconds. The display shows AutoMute. Since the RX45 will beep and display Program. (Brightness is at maximum during this factory setting is for AutoMute to be on, the RX45 will display aMute ON. process.) If you accidentally don't release the 2 Then press the RVW button to review the current settings. You can either tap the button to change from item to item, or RVW button in time and it goes to the next category, simply hold the RVW button down again until aMute is displayed. hold the button to scroll through the items. 3 Press the CHG button to change any setting. You can either tap the button to 4 Press the CHG button to change from aMute ON to aMute OFF. change from setting to setting, or hold the button to scroll through all the options. 5 To complete this change, simply wait 8 seconds without pressing any button. The 4 To leave Programming, simply wait 8 seconds without pressing any button. The unit will display Complete, beep and return to normal operation. display will provide a Complete message, accompanied by an audible tone.This is an indication that the RX45 has returned to its normal operation. To quickly return to all of the factory defaults, press and hold the BRT and SENS buttons while turning on the unit. 12 Overview of Preferences Press the REVIEW button to go from one category to the next PILOT LIGHT (Power-on indication) SIGNAL STRENGTH METER AUTOMUTE VOICE BANDS *Factory Default Settings To reset the RX45 to its original factory settings,press and hold the "BRT" and "SENS" buttons while turning the power on. The display will provide a Reset message, accompanied by an audible tone, acknowledging the reset. Press the CHANGE button to change your setting within a category Pilot HWY Pilot H Pilot V * Full word:Highway,AutoScan,AutoNoX Letter: H or A or ANX Vehicle voltage Meter STD Meter THT Meter TEC * Standard signal strength meter ThreatDisplay TechDisplay aMute ON aMute OFF * AutoMute on AutoMute off Voice ON Voice OFF * Voice alerts on Voice alerts off Bands DFT Bands MOD * Factory default settings One or more bands have been changed Turn bands on or off by pressing and holding the V•MUTE button X ON or OFF (default is on) Ku ON or OFF (default is off) K ON or OFF (default is on) Ka ON or OFF (default is on) POP ON or OFF (default is off) SWS ON or OFF (default is off) LSR ON or OFF (default is on) TSR ON or OFF (default is off) 13