BenQ DC2410 User Manual - Page 6

Preparing your DC 2410 for using, 2.1. How to Switch On or Switch Off The Camera, REPARING, USING - dc 2410 manual

Get BenQ DC2410 PDF manuals and user guides View all BenQ DC2410 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

BenQ DC 2410 User's Manual 2. PREPARING YOUR DC 2410 FOR USING 2.1. How to Switch On or Switch Off The Camera Slide the "POWER" switch sideways and hold it a while to switch on the camera. Repeat the action above to switch off the camera. Load the Batteries: 1. Check if the camera is switched off. 2. Slide the Battery / Memory Card Cover out to open it. 3. Load 2 x AA batteries into the battery chamber, following the polarity indications. 4. Close the Battery / Memory Card Cover. Note The below symbols are the indication of the battery status on the TFT LCD Monitor. ( ) Battery power is full. ( ) Battery power is half drained. Have new batteries ready. ( ) Battery power is drained. Replace the batteries you are using now. Note Please use the below suggested battery to ensure that the battery is of acceptable quality to support the camera's operation: Brand Duracell Ultra Type Alkaline Note 1. Batteries may lose power if kept inside the camera for a long time without using. Please remove the batteries while the camera is not in use. 2. Do not use manganese batteries as they cannot supply sufficient power to support the camera's operation. 3. Batteries may not work normally under 0ºC. 4. It's normal that the temperature of the camera body rises a little after being in use for a long period. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
BenQ DC 2410
User’s Manual
3
2. P
REPARING
YOUR
DC 2410
FOR
USING
2.1. How to Switch On or Switch Off The Camera
Slide the "POWER" switch sideways and hold it a
while to switch on the camera. Repeat the action
above to switch off the camera.
Load the Batteries:
1. Check if the camera is switched off.
2. Slide the Battery / Memory Card Cover out to open it.
3. Load 2 x AA batteries into the battery chamber, following
the polarity indications.
4. Close the Battery / Memory Card Cover.
Note
The below symbols are the indication of the battery status on the TFT LCD Monitor.
(
) Battery power is full.
(
) Battery power is half drained. Have new batteries ready.
(
) Battery power is drained. Replace the batteries you are using now.
Note
Please use the below suggested battery to ensure that the battery is of acceptable
quality to support the camera's operation:
Brand
Type
Duracell Ultra
Alkaline
Note
1. Batteries may lose power if kept inside the camera for a long time without using.
Please remove the batteries while the camera is not in use.
2. Do not use manganese batteries as they cannot supply sufficient power to support
the camera's operation.
3. Batteries may not work normally under 0ºC.
4. It's normal that the temperature of the camera body rises a little after being in use for
a long period.