BenQ MP510 User's Manual - Page 23

iii. Press Down to cancel the password set-up and return to the OSD menu. To disable password protection, go to the Setting > Password menu after opening the OSD menu system. Select Off by pressing Left or Right. Though the password function is disabled, you need to keep the old password in hand should you ever need to turn the password function back on and change the old password. If you forget the password If the password function is activated, you will be asked to enter the four digit password every time you turn on the projector. If you enter the wrong password, the password error message displays. You can retry by pressing Up, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure. Password error Try again Forgot password? Please refer to the User's Manual Entering the password recall procedure Press and hold Right on the projector for 3 seconds. The projector will display 4 sets of coded number on the screen. Write down the number and turn off your projector. Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector. Changing the password 1. Press MENU on the projector or MENU on the remote control to open the on- screen menu and go to the Setting > Change Password menu. 2. Press Left or Right. 3. Enter the old password. i. If the password is correct, you can go on to enter new password. ii. If the password is incorrect, a "Password Error" message displays. Press Up to try again or press Down to cancel. 4. Enter a new password. The digits being input will display as asterisks on-screen. Write your selected password down here in this manual in advance or right after the password is entered so that it is available to you should you ever forget it. Password Keep this manual in a safe place. 5. Perform one of the following 3 steps. i. Press AUTO to confirm. ii. Press Up to try again. iii. Press Down to cancel the set-up and return to the on-screen menu. 6. Confirm the new password by re-entering the new password. 7. Perform one of the following 3 steps. i. Pressing AUTO completes the procedure. ii. Press Up to try again. iii. Press Down to cancel the set-up and return to the on-screen menu. Operation 23