BenQ MP510 User's Manual - Page 42
Replacing the lamp, replaced before the projector will operate normally. - lamp reset
UPC - 840046017262
View all BenQ MP510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Lamp-usage time exceeded Replace lamp (refer to User Manual) Then reset lamp timer If this warning message displays, the projector will shut down in 40 seconds. The lamp MUST be replaced before the projector will operate normally. Replacing the lamp • To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before changing the lamp. • To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the lamp. • To reduce the risk of injuries to fingers and damage to internal components, use caution when removing lamp glass that has shattered into sharp pieces. • To reduce the risk of injuries to fingers and/or compromising picture quality by touching the lens, do not touch the empty lamp compartment when the lamp is removed. • This lamp contains mercury. Consult your local hazardous waste regulations to dispose of this lamp in a proper manner. 1. Turn the power off and disconnect the projector from the wall socket. If the lamp is hot, avoid burns by waiting for approximately 45 minutes until the lamp has cooled. 2. Turn the projector over. Then loosen the screws on the lamp cover. 3. Remove the lamp cover from the projector. Do not turn the power on with the lamp cover removed. 4. Remove the lamp cords from the slots. 42 Maintenance