BenQ W3000 User Manual - Page 44
Switching input signal
View all BenQ W3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Switching input signal The projector can be connected to multiple devices at the same time. However, it can only display one full screen at a time. If you want the projector to always automatically search for the signals: • Under the Advanced OSD menu, go to the System Setup : Basic menu, and enable Auto Source Search. (see "Auto Source Search" on page 38) • Under the Basic OSD menu, if there's no signal connected to the projector, go to Auto Source Search and enable it; if there are signals connected, go to the Settings menu, and then enable Auto Source Search. (see "Auto Source Search" on page 38 and 39) You can also manually cycle through the available input signals. 1. Press SOURCE on the projector or press input source directly from the remote control. A source selection bar displays. 2. Press ▲/▼ until your desired signal is selected and press OK. Once detected, the selected source information will display on the screen for seconds. If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another signal. • The brightness level of the projected image will change accordingly when you switch between different input signals. Data (graphic) "PC" presentations using mostly static images are generally brighter than "Video" using mostly moving images (movies). • The native display resolution of this projector is in a 16:9 aspect ratio. For best display picture results, you should select and use an input signal which outputs at this resolution. Any other resolutions will be scaled by the projector depending upon the 'aspect ratio' setting, which may cause some image distortion or loss of picture clarity. See "Aspect Ratio" on page 52 for details. You can also rename the source: 1. Press MENU and then press ◄/► until the System Setup: Basic menu is highlighted. 2. Press ▼ to highlight Source Rename and press OK. The Source Rename page displays. 3. Press until your desired character is selected and press OK. 44 Menu Functions