Beretta A400 Xcel Parallel Target Kick-Off User Manual - Page 27

Routine Maintenance

Page 27 highlights

WARNING: Never shoot the choke barrel without inserting a choke tube. Shooting without a choke tube in the barrel is very dangerous, as residues of lead or debris may become lodged in the thread creating an obstruction within the barrel. Also, not using a choke tube will damage the threading of the barrel irreparably and result in irregular shot spread. Do not alter or modify an existing fixed choke Beretta barrel for the use of interchangeable choke tubes. The barrel wall thickness would be too thin to safely contain the pressure levels generated by shooting. ROUTINE MAINTENANCE Clean and lubricate your shotgun any time combustion residue, grease or dirt is deposited in any of the mechanisms. Cleaning and lubrication of the firearm after each use is the best way of ensuring that the components are protected against combustion corrosion or rusting from use in humid or salty environments. At the end of a shooting day, carry out the Routine Maintenance as indicated below. WARNING: Always check that the shotgun is unloaded (empty cartridge chamber, empty receiver, empty magazine). Inspect the firearm by looking through the ejection port, the loading gate and the chamber. If it is not empty, unload it as instructed in the relevant section. Check that the hammer is decocked. WARNING: Never point the firearm at someone or at hard, flat surfaces. Always treat the shotgun as if it were loaded. (See points 1, 2 and 4 of the BASIC SAFETY RULES). NOTICE: For Routine Maintenance, simply disassemble it following the procedures described in the relevant section. BARREL • Carefully clean the inside of the barrel with a soft cloth (flannel) to remove any combustion residue. If necessary, use a bronze brush or a cloth soaked with Beretta Gun Oil. • Thoroughly clean the locking shoulders on the barrel breech. • Pull a soft, clean, dry cloth through the barrel. • Lightly lubricate the barrel with a soft clean cloth soaked with Beretta Gun Oil. • Check the barrel. The barrel and cartridge chamber must be clean and free from obstructions. CAUTION: Excess oil or grease obstructing the barrel, even partially, is very dangerous when firing and may cause damage to the shotgun and serious injury to the shooter and to bystanders. Never spray or apply oil to the cartridges. Use lubricants properly. You are responsible for the proper care and maintenance of your firearm. ! EN ! ! ! ! 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35

29
EN
WARNING:
Never shoot the choke barrel without inserting a choke tube.
Shooting without a choke tube in the barrel is very dangerous, as residues of
lead or debris may become lodged in the thread creating an obstruction within
the barrel. Also, not using a choke tube will damage the threading of the barrel
irreparably and result in irregular shot spread.
Do not alter or modify an existing
xed choke Beretta barrel for the use of
interchangeable choke tubes. The barrel wall thickness would be too thin to
safely contain the pressure levels generated by shooting.
ROUTINE MAINTENANCE
Clean and lubricate your shotgun any time combustion residue, grease or dirt is
deposited in any of the mechanisms. Cleaning and lubrication of the
rearm after
each use is the best way of ensuring that the components are protected against
combustion corrosion or rusting from use in humid or salty environments.
At the end of a shooting day, carry out the Routine Maintenance as indicated
below.
WARNING:
Always check that the shotgun is unloaded (empty cartridge chamber,
empty receiver, empty magazine). Inspect the
rearm by looking through the
ejection port, the loading gate and the chamber. If it is not empty, unload it as
instructed in the relevant section. Check that the hammer is decocked.
WARNING:
Never point the
rearm at someone or at hard,
at surfaces. Always
treat the shotgun as if it were loaded. (See points 1, 2 and 4 of the BASIC
SAFETY RULES).
NOTICE:
For Routine Maintenance, simply disassemble it following the
procedures described in the relevant section.
BARREL
• Carefully clean the inside of the barrel with a soft cloth (
annel) to remove any
combustion residue. If necessary, use a bronze brush or a cloth soaked with
Beretta Gun Oil.
• Thoroughly clean the locking shoulders on the barrel breech.
• Pull a soft, clean, dry cloth through the barrel.
• Lightly lubricate the barrel with a soft clean cloth soaked with Beretta Gun Oil.
• Check the barrel. The barrel and cartridge chamber must be clean and free
from obstructions.
CAUTION:
Excess oil or grease obstructing the barrel, even partially, is very
dangerous when
ring and may cause damage to the shotgun and serious injury
to the shooter and to bystanders. Never spray or apply oil to the cartridges. Use
lubricants properly. You are responsible for the proper care and maintenance of
your
rearm.
!
!
!
!
!