Beretta A400 Xcel Parallel Target Kick-Off User Manual - Page 32
Replacing The Stock Drop And Cast Spacers, Required Tools, Field Stripping
View all Beretta A400 Xcel Parallel Target Kick-Off manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
! ! EN REPLACING THE STOCK DROP AND CAST SPACERS NOTICE: The right-hand cast is designated by the initials DX. The left-hand cast is designated by the initials SX. The drop and cast of the front spacer and plate must always be synchronised. WARNING: Stock drop and cast modification must be carried out by a competent gunsmith. Failure to comply with these instructions can lead to damage to property or injury to persons REQUIRED TOOLS 1 Philips and 1 flat-head screwdriver. 1 Torque wrench T15 1 Hexagonal spanner, 6 mm. 1 Tube spanner, 13 mm. 1 Torque wrench (previously mentioned) with a 13-mm pipe extension. FIELD STRIPPING • Use the Phillips screwdriver to remove the two screws sunk into the stock. • Remove the Beretta Microcore recoil pad from the stock or Kick Off (Only for Kick Off versions). • (Only for Kick Off versions) Remove the Kick Off recoil absorption device by unscrewing the special screws using a Torx T15 screwdriver. • Use the 13-mm tube spanner to completely unscrew the retaining nut of the stock and remove the nut, spring washer and plate . • Separate the stock from the receiver and remove the plate . 34