Bernina Artista 630 User Guide - Page 114

114 Preparing for Embroidery Preparing the Embroidery Computer for Embroidery Embroidery Presser Foot No. 26 • attach the Embroidery presser foot No. 26 • raise the presser foot so that the embroidery hoop can be attached 17 18 Needles for Embroidery • depending on the embroidery thread use needle size 75 to 90 • use special embroidery or Metafil needle for embroidery or metallic thread • use an undamaged needle • raise the needle so that the embroidery hoop can be attached Lower the Feed Dog • press the button on the right side of the sewing computer to lower the feed dog Straight Stitch Plate (optional accessory) • the straight stitch plate has a small needle hole. The needle insertion points (upper and lower thread stitching) are limited, which produces a better embroidery result • remove the standard stitch plate and replace it with the straight stitch plate 20 Threading Upper and Bobbin Thread 3 5 Threading the Upper Thread • attach foam pad and place the upper thread spool • when using Rayon or slippery embroidery threads, slip the net over the upper thread spool • this prevents the upper thread from slipping and gives an even thread feed Threading the Bobbin Thread • for embroidery, insert the thread into the finger of the bobbin Adjusting the Thread Tension The artista 630 has manually adjusted thread tension. • the tension should be set to between 2.5 - 4.5 for all embroidery • adjustments for difficult or unusual fabrics can be made if necessary 10 While embroidering the bobbin can also be wound, just like in sewing. Spool pin When using metallic or specialty threads, using the vertical spool pin and the 13 supplementary thread guide (optional accessory) may also help avoid problems. 031196.50.04_0507_a630_EN