Biostar TP45 HP Setup Manual - Page 24
Step 2, Step 3, Step 4
![]() |
View all Biostar TP45 HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Motherboard Manual Step 2: Insert the two CrossFire-Ready graphics cards into PEX16_1 (Master) and PEX16_2 (Slave) PEX16_1(Mas ter ) PEX16_2(Slave) Notice: Make sure both the graphics cards are seated into slots completely. Step 3: Connect a 4-pin ATX power cable to Auxiliary Power Connector (J1), this will ensure the stabilization of your system. Step 4: Connect the CrossFire Bridge with two graphics cards. Installation completes. NOTE For more detail information of hardware/software installation and configuration of CrossFire function, please visit following web-sites: http://ati.amd.co m/te chnology/ cro ssfire/tutorials.html http://ati.amd.co m/te chnology/ cro ssfire/howitworksdemo.ht ml 22
![](/manual_guide/products/biostar-tp45-hp-setup-manual-70b74ad/24.png)
Motherboard Manual
22
Step 2
: Insert the two CrossFire-Ready graphics cards into PEX16_1 (Master)
and PEX16_2 (Slave)
PEX16_1(Master)
PEX16_2(Slave)
Notice:
Make sure both the graphics cards are seated into slots
completely.
Step 3
: Connect a 4-pin ATX power cable to
Auxiliary Power
Connector (J1),
this will ensure the stabilization of your system.
Step 4
: Connect the CrossFire Bridge with two graphics cards. Installation
completes.
NOTE
For more detail information of hardware/software installation and
configuration of CrossFire function, please visit following web-sites: