Bissell CleanView Bagless Vacuum Cleaner 1831 User Guide - Page 9

Maintenance: Brush & Belt 1 2 Unplug vacuum, turn over and unscrew six (6) Philips head screws to remove the bottom cover. Clean debris from brush roll. Inspect by placing it on its end and spin. The brush roll should spin freely, multiple times by one flick. If it doesn't, replace brush roll. Check belt for wear or cuts and replace if necessary. 3 Belt Thread belt and line up End Cap to reassemble roller. Replace bottom cover and 6 screws. End Cap NOTE: If an object becomes lodged in foot and brush shuts off, turn vacuum off and unplug from electrical outlet. Remove obstruction and brush will automatically reset when vacuum is plugged and turned back on. Maintenance: TurboBrush® & TurboEraser® Tool 1 2 Align Slot 3 Paddle Wheel Clip Roller Belt Twist gray collar counter clockwise, until slot appears, then separate faceplate. Remove brush roll, belt, and paddle wheel. Inspect for damages and replace if necessary. Paddle Wheel End To reassemble, align two clips on each end of paddle wheel with belt on and pop back into place. Place brush roll with belt back in. Faceplate will not close properly if all parts are not aligned correctly. www.BISSELL.com 9