Bissell CleanView Helix Vacuum User Guide - English - Page 10

Maintenance and care Cleaning the pre-motor filter 1. Unplug the cleaner from electrical outlet. 2. The pre-motor filter protects the motor from debris. It is located underneath the filter cup in the center of the round part of the Lock 'n Seal lever. 3. Remove the small round filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing. Replacing the post-motor filter Use only genuine BISSELL style 9 (#32076) replacement filters in your BISSELL Cleanview Helix. 1. Unplug the cleaner from electrical outlet. 2. The post-motor filter assists in the filtration process to return clean air to the room. It is located behind the door on the side of the vacuum. When the filter becomes dirty, open the door, remove the filter and replace. The white, pleated HEPA media filter is not washable. Note: A basic washable post-motor filter with reduced filtration is available if desired. WARNING: Do not operate cleaner with damp or wet filters or without all filters in place. Pre-Motor Filter Post-Motor Filter WARNING: To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect Power Plug from electrical outlet. 10 w w w . b i s s e l l . c o m 800.237.7691