Bissell CleanView Helix Vacuum User Guide - English - Page 9

Maintenance and care Empty Dirt Container 2. The dirt container needs to be emptied when the dirt reaches the "Full" line on the side of the container. 1. Unplug cleaner from electrical outlet. 2. Slide the Lock 'n Seal lever to the "Unlock" Unlock Position position. 3. Grasp dirt cup portion handle and pull straight out to remove from vacuum. 4. Empty dirt into garbage container. 3. 5. Put the dirt container back in the vacuum and slide the lever to the "Lock" position. Note: The dirt container may be washed in warm water with a mild detergent. Make sure it is completely dry before replacing. Full Line Lock Position Cleaning the inner & outer circular filter Use only genuine BISSELL style replacement filters in your BISSELL Cleanview Helix. 1. Unplug the cleaner from electrical outlet. 2. 2. Remove the dirt container as described in the previous section. Grasp the filter cup located at the bottom of the dirt container, lift up and out. Do not try to pull circular foam filter out of the filter cup while it is still in the vacuum. 3. Grasp the plastic tab on the top of the circular 3. foam filters. Twist to unlock and pull out. 4. Separate the outer foam and inner pleated circular filters. Wash each individually by hand in warm water. Mild detergent may be used if desired. Rinse well, then air dry thoroughly before putting them back together and replacing in filter cup. 5. The filter cup may be washed in warm water with a mild detergent. Make sure it is completely dry before reassembling with filters. 4. 6. The upper tank and louvers may also be wiped clean with a damp cloth. Reach underneath the upper tank and turn the rim of the louvers to unlock. Pull straight down to remove. Make sure all parts are dry before replacing. www.bissell.com 800.237.7691 9