Bissell CrossWave HF3 Cordless Multi-Surface Wet Dry Vac 3649A User Guide - Page 6
Using the Self-Cleaning Cycle, After-Cleaning Care
View all Bissell CrossWave HF3 Cordless Multi-Surface Wet Dry Vac 3649A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Using the Self-Cleaning Cycle 1. Place the machine on the docking station. Make sure there is cleaning formula in the clean water tank and the dirty water tank is empty. 2. Press the self-cleaning button to start the cycle. The button light will pulse while cycle is running. 3. Once complete, remove the brush roll to dry. See "After- Cleaning Care" for instructions. After-Cleaning Care Go to support.BISSELL.com for a full list of how-to videos. 1. Empty the dirty water tank. To remove, press the button on the top of the tank, grab the front handle and pull tank out. 2. Hold the top of the tank near the sides of the filter and pull up to remove. 3. Use the strainer on the clean-out brush to strain debris out of dirty water while pouring into a utility sink or similar waste water receptacle. Dispose of debris in trash and rinse the tank. 4. Remove the pleated filter from the top of the tank by pulling up. 5. Wash filter with warm water and mild detergent. Rinse the bottom of the tank cover. Note: Filter must be completely dry before reinstalling. 6. Remove the brush roll cover. CONTINUED ON NEXT PAGE 6 BISSELL.com